What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 25.06.2025 17:40
The other is “what does a “fuse” do?”
Because the load is inductive, the current lags the voltage.(by a bit).
This is the picture of an electronic coil of wire wound around a core of magnetic material.
What are some recommended foods for reducing eye fatigue?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–14 [Omar Gharbi Omar Gharbi ]
What is the best way to end a relationship with someone who has future plans with you?
There are two important concepts here.
This is where this question deviates from being a 'generic' question, and becomes more specific.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
the problem then depends on "how fast does the fuse operate?".
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
One
Is the Chinese economy currently collapsing? If not, what could potentially cause it to collapse?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Measles strikes at birth: Six Canadian newborns infected from unvaccinated mothers - Times of India
The MOV will conduct when the voltage exceeds 50% of line voltage.
what exactly is a ‘surge’ protector?
At least they know the answer if they wanted it.
This one hit behind the barn.
At one ohm, the resistor has a maximum of 1 watt power.
A circuit breaker is similar, but is resettable.
How is Taylor Swift feeling after Trump’s landslide victory over Kamala Harris?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
So, the voltage could go up to 500 volts, and the fuse will not open up.
What is lightning?
Who is/was the genuinely toughest actor in Hollywood movies?
(Dc diagram shown, AC is similar).
The third is lightning and “how it gets conducted into a home.”
The bolt then partially travels down the line to your home.
This is the safest place to hide when a nuclear bomb strikes - The Brighter Side of News
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
a photo is worth a thousand words.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
It also is a device that limits the change in current flow.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
[old diagram got deleted by accident]
Barnstars:
These are simplified answers to the original question, and does not change anything I wrote above.
I post the exact comment here.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is 'the assistant's answer'
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This device then solves the entire problem.
Here is a simplified AC power diagram.
An AC voltage/ current source, and an ac inductive load.
There are three different concepts here that are getting confused.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
In schematic diagrams this is the symbol for a fuse:
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
but this device (an Inductor) … impedes the rapid changes in the current.
It seems Mohan does not understand the difference between a comment and an Answer.
But it can get overloaded, and no longer works.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Now when you have a certain ac resistance, then a current flows in a loop.
He then describes the function of a fuse.
A fuse is a non-resetable over current circuit protector.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
but I think this circuit , shows a few more pieces.
For this case there are devices called Metal oxide varistors (MOV).
He then asserts :
2024–10–16 [ OO OLAOYE OYEBODE ]
Upvotes:
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
These devices are installed between the “hot” and “neutral” and protective ground.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is where the MOV conducts again, and dissipated the energy.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–10[John johnson John Johnson ]
What does a fuse do?
First Sentence:
eight
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
[image of Common-mode choke]
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
so, what happens?
nine
Edit 2024–10.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
One is “what exactly is in a ‘surge protector’ ? ”
But… the neutral is now “floating” because of the 1 ohm resistance.
He then describes Rainy Season and Lightning.